Meshing Problem
 

Hey Folks,

happy new year! I'm making a small gap analysis and therefore i have a part of a circlegeomtry which I tried to block and mesh.

I have done a similiar part last year but not with the kind of arc. Normally i would think that there should not be a problem and most of the blocking and meshing did work without any prolbems. (At least it is an easy geometry)
But there is a small wall where the mesh does not fit like it should be (See attached files).

I have attached also the project file, if the pictures are not meaningful enough.

Kind regards
John

When I started last year with this task it was just not working. But now, after some time to think about it and to get a new perspetciv i found the problem :-).
There was just a edge missing, don't know where it went. I did a new blocking and now it's working. Really annoying if the problem was such a simple one and I did not catch it because the blocking is so unclear.