[DesignModeler] face split -- CFD Online Discussion Forums

March 7, 2013, 04:40

face split

bikalpa10

New Member

Bikalpa Bomjan Gurung

Join Date: Mar 2013

Posts: 12

Rep Power: 13

i need to split the cylinder into two parts as in figure
so that i can set one side as inlet and other as outlet.
if u have any idea please reply

i am using ansys designmodeler

Attached Images

airwing-geometry.jpg (47.4 KB, 31 views)

March 7, 2013, 10:24		#2
diamondx Super Moderator Ghazlani M. Ali Join Date: May 2011 Location: Tokyo, Japan Posts: 1,385 Blog Entries: 23 Rep Power: 28	tools -» split face bikalpa10 likes this. __________________ Regards, New to ICEM CFD, try this document --> https://goo.gl/KAOIwm Ali

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
[Netgen] Import netgen mesh to OpenFOAM	hsieh	OpenFOAM Meshing & Mesh Conversion	32	September 13, 2011 05:50
[blockMesh] BlockMeshmergePatchPairs	hjasak	OpenFOAM Meshing & Mesh Conversion	11	August 15, 2008 07:36
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55
[blockMesh] Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Meshing & Mesh Conversion	10	April 2, 2007 14:00

All times are GMT -4. The time now is 14:18.