|
[Sponsors] |
July 29, 2015, 07:17 |
No Inflation layer on aerofoil
|
#1 |
Member
Join Date: Dec 2012
Posts: 81
Rep Power: 13 |
Hi there,
I am currently facing a problem with my ICEM mesh. I would like to create inflation layers around my aerofoil and used the part mesh setup in ICEM to do so. However, the premesh doesnt show any inflation layers and I dont really understand why that is the case. I have attached 2 pictures for clarification. It would be great if someone could help me out with this many thanks in advance!!! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Inflation layer / Element quality | Spookz | ANSYS Meshing & Geometry | 17 | February 12, 2019 04:55 |
[snappyHexMesh] snappyHexMesh Boundary Layer at Corner | panpanzhong | OpenFOAM Meshing & Mesh Conversion | 5 | July 3, 2018 05:53 |
Prismatic boundary layer | KateEisenhower | enGrid | 5 | September 15, 2015 07:48 |
[snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 13:47 |
errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |