CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] meshing (http://www.cfd-online.com/Forums/ansys-meshing/111540-meshing.html)

tmeysam92 January 9, 2013 12:02

meshing
 
2 Attachment(s)
Hello,

I want to mesh the valve (Fig.1) in ICEM.
If you look at the geometry (Fig. 2), you see that there is a hole in it, but when i use blocking startegy , I do not know how to produce the hole in blocking. what should i do?

thanks in advance.

diamondx January 9, 2013 12:07

make splits until you get a block that has same topology as the hole. then delete it...


All times are GMT -4. The time now is 00:57.