CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] Problem with prism layer (http://www.cfd-online.com/Forums/ansys-meshing/111775-problem-prism-layer.html)

j_h_86 January 15, 2013 05:33
Problem with prism layer
 
1 Attachment(s)
Hello,

I am creating an hybrid mesh right now. Unfortunately I have some problems with the prism layers. The set value of 30 layers is not always reached and decreases to the edge (left and right) and also sometimes in the middle of the surface (see attached image).

Any ideas?

Thank you very much.

Far January 15, 2013 05:44
which software? I seems parameters are not set at curves....

j_h_86 January 15, 2013 05:53
Quote:
Originally Posted by Far (Post 401921)
which software? I seems parameters are not set at curves....
Oh sorry I forgot: ICEMCFD.

Which curves should I specify further? The curves orthogonal to the wall, where I want to create the prism-layers or all of the curves?

Best regards

Far January 15, 2013 07:06
Its a 2d case?

j_h_86 January 15, 2013 07:13
No, it is 3d. I try to mesh a 30° section of a sinusoidal surface.


All times are GMT -4. The time now is 22:53.