|
[Sponsors] |
January 22, 2013, 08:21 |
Meshing an airfoil with Hexa in ICEM
|
#1 |
Member
Join Date: Feb 2010
Posts: 50
Rep Power: 16 |
Dear all,
I am trying to mesh an airfoil in icem. Simon has uploaded an instruction on youtube showing the basic steps. I am currently using ICEM 14.5. Everything is clear and works fine. Just the final smoothing that should create orthogonality does not perform that well. I am trying to create a very fine grid in the sub-boundray layer. The smoother restricts the smoothing on the 2-3 layers next to the surface. how is it possible to force ICEM to propagate the smoothing into the volume? It works fine in case I use cells with a relatively large cell height as first layer. Any help is highly appreciated Kind regards Philipp |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Having several dificulties with 3d airfoil meshing in ICEM CFD | Teja | ANSYS Meshing & Geometry | 14 | February 23, 2015 13:01 |
[ICEM] ICEM Hexa meshing tutorial - Wing with sharp trailing edge | Far | ANSYS Meshing & Geometry | 34 | October 21, 2013 05:46 |
ICEM Hexa meshing tutorial - Wing with sharp trailing edge | Far | ANSYS | 1 | May 18, 2012 14:19 |
Wind tunnel hexa meshing in ICEM CFD 12.1 | matheusguzella | ANSYS Meshing & Geometry | 1 | March 14, 2011 16:14 |
ICEM Meshing | Jaloha | CFX | 0 | April 1, 2008 06:24 |