How to mesh an orifice in ICEM
1 Attachment(s)
Hi,
I am a new user of ICEM. I wanto to mesh an hydraulic orifice (Hex mesh). Can anyone suggest some tutorial that I can follow or just write what is the procedure that I need to carry out ? Here is the geometry of my case Thanks Marco |
Quote:
I would prefer doing this tutorial first. It will help you a lot ANSYS ICEM CFD HEXA 3D Elbow Tutorial You can get the tutorials files from Ansys customer portal. Regards, Smaras |
Hi Smaras,
I have already had a look to this tutorial but it did not help me so much. What I have done is : -create parts (inlet, outlet, wall and two symmetry plane) -create a block -create an o-grid -try to split block (without good results) is it right?? Thanks Marco |
|
Hi Ali,
sorry for the late response! I got my mesh with ICEM !! Thanks to your link too! So ..THX Best Regards Marco |
All times are GMT -4. The time now is 09:06. |