CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [Other] Meshing for 2D analysis of blower in Hypermesh (http://www.cfd-online.com/Forums/ansys-meshing/112541-meshing-2d-analysis-blower-hypermesh.html)

Akash C January 30, 2013 14:53

Meshing for 2D analysis of blower in Hypermesh
 
Hi,
As the title suggests I am trying to mesh the 2D model of a blower for subsequent analysis in Fluent. The procedure that I am following is proving to be quite cumbersome.
First I surface mesh all the regions. Then for the boundaries I have to create line mesh using the nodes available at the outlines of these surface meshes. This process requires selection of all the nodes at the boundaries which is increasing our meshing time.
Anyone having prior experience with hypermesh as pre processor for fluent please help.


All times are GMT -4. The time now is 19:28.