 |
 |
 |
|
|
|
[Sponsors] | ||||
[Other] Meshing for 2D analysis of blower in Hypermesh |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 30, 2013, 13:53
|
Meshing for 2D analysis of blower in Hypermesh
|
#1 |
|
Member
Akash Chaudhari
Join Date: Dec 2012
Location: Pune, India
Posts: 31
Rep Power: 13  |
Hi,
As the title suggests I am trying to mesh the 2D model of a blower for subsequent analysis in Fluent. The procedure that I am following is proving to be quite cumbersome. First I surface mesh all the regions. Then for the boundaries I have to create line mesh using the nodes available at the outlines of these surface meshes. This process requires selection of all the nodes at the boundaries which is increasing our meshing time. Anyone having prior experience with hypermesh as pre processor for fluent please help. |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [GAMBIT] Meshing in Gambit for analysis of flow past cylinders | mahi007 | ANSYS Meshing & Geometry | 66 | October 24, 2017 02:27 |
| [Other] Meshing for 2D analysis of blower in Hypermesh | Akash C | ANSYS Meshing & Geometry | 0 | January 30, 2013 13:56 |
| [ANSYS Meshing] 3D Meshing for CFD analysis of aircraft | nauman55 | ANSYS Meshing & Geometry | 0 | July 25, 2012 14:15 |
| CFD Analysis Of Centrifugal Blower | saurabh9978 | Main CFD Forum | 3 | August 1, 2011 02:55 |
| meshing for structural analysis | Zubair | ANSYS | 0 | April 12, 2009 05:39 |
Linear Mode
