CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [DesignModeler] Update parameters in Solidworks's parameter table (http://www.cfd-online.com/Forums/ansys-meshing/112640-update-parameters-solidworkss-parameter-table.html)

m4D February 1, 2013 12:27

Update parameters in Solidworks's parameter table
 
Hello.

Is it possible to setup DM to actually update Solidoworks' parameter table (excel) after it updates DS_dimensions? My solid design has lots of dimensions (in this table), that are calculated basing on DS-dims, but the table isn't recalculated during WB-update procedure, only DS-dims are.

Thanks in advance.


All times are GMT -4. The time now is 13:14.