CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [GAMBIT] successive ratio on meshing edge (http://www.cfd-online.com/Forums/ansys-meshing/112675-successive-ratio-meshing-edge.html)

domenicoBUFF February 2, 2013 10:50

successive ratio on meshing edge
 
Hi! First meshes with Gambit. Please, how to mesh an edge with n points at increasing distance each other, and starting with the first cell as fixed at for example at 1 m (total edge of 1 km). The control I need is on the first of e.g. 1 m, then I'd apply an incremental ratio, e.g. n = 2 gives 1 m + something (e.g. 0.2 m), etc... Which parameters aren't to be fixed? Is first length to be used in Gambit, and how? Very many thanks!

-mAx- February 4, 2013 03:00

I didn t get your point (maybe a sketch would help)
anyway: http://aerojet.engr.ucdavis.edu/gamb...mesh_edge_mesh


All times are GMT -4. The time now is 13:12.