[GAMBIT] successive ratio on meshing edge

domenicoBUFF · February 2, 2013, 09:50

Hi! First meshes with Gambit. Please, how to mesh an edge with n points at increasing distance each other, and starting with the first cell as fixed at for example at 1 m (total edge of 1 km). The control I need is on the first of e.g. 1 m, then I'd apply an incremental ratio, e.g. n = 2 gives 1 m + something (e.g. 0.2 m), etc... Which parameters aren't to be fixed? Is first length to be used in Gambit, and how? Very many thanks!

-mAx- · February 4, 2013, 02:00

I didn t get your point (maybe a sketch would help)
anyway: http://aerojet.engr.ucdavis.edu/gamb...mesh_edge_mesh

February 2, 2013, 09:50	successive ratio on meshing edge	#1
domenicoBUFF New Member Join Date: Feb 2013 Posts: 5 Rep Power: 13	Hi! First meshes with Gambit. Please, how to mesh an edge with n points at increasing distance each other, and starting with the first cell as fixed at for example at 1 m (total edge of 1 km). The control I need is on the first of e.g. 1 m, then I'd apply an incremental ratio, e.g. n = 2 gives 1 m + something (e.g. 0.2 m), etc... Which parameters aren't to be fixed? Is first length to be used in Gambit, and how? Very many thanks!

February 4, 2013, 02:00		#2
-mAx- Super Moderator Maxime Perelli Join Date: Mar 2009 Location: Switzerland Posts: 3,297 Rep Power: 41	I didn t get your point (maybe a sketch would help) anyway: http://aerojet.engr.ucdavis.edu/gamb...mesh_edge_mesh __________________ In memory of my friend Hervé: CFD engineer & freerider

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
Problem with divergence	TDK	FLUENT	13	December 14, 2018 06:00
pressure eq. "converges" after few time steps	maddalena	OpenFOAM Running, Solving & CFD	69	July 21, 2011 07:42
Where's the singularity/mesh flaw?	audrich	FLUENT	3	August 4, 2009 01:07
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55