|
[Sponsors] |
[ANSYS Meshing] Creating a dense mesh near boundaries |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 7, 2013, 14:38 |
Creating a dense mesh near boundaries
|
#1 |
New Member
Join Date: Feb 2013
Location: Warsaw, Poland
Posts: 1
Rep Power: 0 |
Hello everyone!
I am looking for advice (some tutorial perhaps) about creating meshes in the Ansys workbench. I am new to the software and my knowledge about these matters is close to nothing. After a few tutorials I got the basics, but now I am tasked with creating a 3D mesh for super-critical flows in a pipe - I only know that the mesh is supposed to have the y+ parameter ~1. Any help will be appreciated! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Can I define periodic boundaries in an unstructured mesh? | Aoki | ANSYS Meshing & Geometry | 11 | September 14, 2018 01:52 |
ICEM 12 CFD help creating volume mesh from stl | EmpError | ANSYS | 0 | November 13, 2010 06:38 |
Error when creating ICEM mesh output to CFX | Zoran | CFX | 4 | November 9, 2010 05:13 |
how to extend FSI 2D codes to 3D, need advises | abouziar | Main CFD Forum | 1 | May 30, 2008 04:08 |
How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 09:38 |