CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] Creating a dense mesh near boundaries (http://www.cfd-online.com/Forums/ansys-meshing/112922-creating-dense-mesh-near-boundaries.html)

Pietrak February 7, 2013 15:38

Creating a dense mesh near boundaries
 
Hello everyone!

I am looking for advice (some tutorial perhaps) about creating meshes in the Ansys workbench.

I am new to the software and my knowledge about these matters is close to nothing.
After a few tutorials I got the basics, but now I am tasked with creating a 3D mesh for super-critical flows in a pipe - I only know that the mesh is supposed to have the y+ parameter ~1.

Any help will be appreciated!


All times are GMT -4. The time now is 02:09.