[sfigato]

Hi,

I am a new user of ICEM. I wanto to mesh an hydraulic orifice (Hex mesh). Can anyone suggest some tutorial that I can follow or just write what is the procedure that I need to carry out ?

Here is the geometry of my case

Thanks
Marco

[Smaras]

Originally Posted by sfigato

Hi,

I am a new user of ICEM. I wanto to mesh an hydraulic orifice (Hex mesh). Can anyone suggest some tutorial that I can follow or just write what is the procedure that I need to carry out ?

Here is the geometry of my case

Thanks
Marco

Hello Marco,

I would prefer doing this tutorial first. It will help you a lot
ANSYS ICEM CFD HEXA 3D Elbow Tutorial



You can get the tutorials files from Ansys customer portal.

Regards,
Smaras

[sfigato]

Hi Smaras,

I have already had a look to this tutorial but it did not help me so much. What I have done is :

-create parts (inlet, outlet, wall and two symmetry plane)
-create a block
-create an o-grid
-try to split block (without good results)

is it right??

Thanks
Marco

[diamondx]

http://www.youtube.com/watch?v=InyeCmEuUVM

hope it can help

[sfigato]

Hi Ali,

sorry for the late response! I got my mesh with ICEM !!
Thanks to your link too!

So ..THX

Best Regards
Marco