CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [GAMBIT] Gambit help (http://www.cfd-online.com/Forums/ansys-meshing/113093-gambit-help.html)

alok.cd February 12, 2013 07:25

Gambit help
 
Hi All,

I have a domain like below. Opposite edges have same mesh count.

https://picasaweb.google.com/1162266...25166580661154

Quad/Map or Quad/Submap should mesh the face like this, (I have made it out of 5 different faces just to show you.)

https://picasaweb.google.com/1162266...25169778632082

But when I mesh it as a single face, it becomes,

https://picasaweb.google.com/1162266...25170248959090

Any thoughts?

Thanks

-mAx- February 12, 2013 09:09

Quote:

Originally Posted by alok.cd (Post 407371)
Quad/Map or Quad/Submap should mesh the face like this, (I have made it out of 5 different faces just to show you.)
https://picasaweb.google.com/1162266...25169778632082
Thanks

You didn't make the decomposition for us, but for you :) since it is the right way.
With surface decomposition, you always have more control on your mesh.
You just demonstrated it
:D

alok.cd February 12, 2013 09:17

Quote:

Originally Posted by -mAx- (Post 407400)
You didn't make the decomposition for us, but for you :) since it is the right way.
With surface decomposition, you always have more control on your mesh.
You just demonstrated it
:D

Thanks mAx, I should have saved it!

alok.cd February 12, 2013 12:24

hi mAx,

Now that I have 2 zones, what should be the boundary type for the edge that connects these two? Interface??

Thanks in advance!

-mAx- February 13, 2013 06:01

don't set anything on this edge. Thus if your split is well done, then both domains are connected, and Gambit will automatically set this edge as interior.

alok.cd February 14, 2013 04:15

Quote:

Originally Posted by -mAx- (Post 407571)
don't set anything on this edge. Thus if your split is well done, then both domains are connected, and Gambit will automatically set this edge as interior.

Worked. Thanks a lot..


All times are GMT -4. The time now is 22:32.