|February 16, 2013, 12:42||
Join Date: Jun 2011
Posts: 134Rep Power: 7
i meshed my geometry in ICEM CFD, but it gives me error(please see the picture).
could someone please help me?
tanks in advance.
|February 16, 2013, 14:46||
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Blog Entries: 23Rep Power: 21
you used interactive icem cfd from ansys meshing ? the meshing has to be very delicate, if you change one small feature in the geometry you will not be able to bring it back in ansys meshing. make sure you didn't
New to ICEM CFD, try this document --> https://goo.gl/NEbygB
|Thread||Thread Starter||Forum||Replies||Last Post|
|UDF compiling problem||Wouter||Fluent UDF and Scheme Programming||6||June 6, 2012 04:43|
|Gambit - meshing over airfoil wrapping (?) problem||JFDC||FLUENT||1||July 11, 2011 05:59|
|natural convection problem for a CHT problem||Se-Hee||CFX||2||June 10, 2007 06:29|
|Adiabatic and Rotating wall (Convection problem)||ParodDav||CFX||5||April 29, 2007 19:13|
|Is this problem well posed?||Thomas P. Abraham||Main CFD Forum||5||September 8, 1999 14:52|