CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (https://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] extend prism layer (https://www.cfd-online.com/Forums/ansys-meshing/113545-extend-prism-layer.html)

foolboy007 February 21, 2013 12:31
extend prism layer
 
2 Attachment(s)
Could anybody help me to extend the prism layer to the end of outlet?
It was good like the second picture.
However, after I define the initial height for each part and generate mesh, the prism layer cannot reach to the end of outlet and inlet.

mjgraf February 21, 2013 14:09
might be an odd setting on the outlet face or curve.


Quote:
Originally Posted by foolboy007 (Post 409364)
Could anybody help me to extend the prism layer to the end of outlet?
It was good like the second picture.
However, after I define the initial height for each part and generate mesh, the prism layer cannot reach to the end of outlet and inlet.


All times are GMT -4. The time now is 13:55.