CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] Selecting inner faces (http://www.cfd-online.com/Forums/ansys-meshing/113653-selecting-inner-faces.html)

jasdeep2006singh February 24, 2013 12:45

Selecting inner faces
 
This might sound like a silly question but how to select an inner surface in a solid.
I am trying to do an aircraft wing analysis. in order to have higher density mesh near the surface of the wing, i am selecting the 'face sizing' option in mesh. it is okay with half wing since the wall is at the root of the wing. how to do 'inside' when the 'wing shaped hole' in inside the control volume.

jrunsten February 25, 2013 02:56

Click where you see the surface and then go "trough" other surfaces by selecing the appropriate layer:

http://i.imgur.com/czBa817.png

Hard to explain in words, but I hope you get it

jasdeep2006singh February 25, 2013 06:23

Thank you
 
Snap showed it all, thank you very much


All times are GMT -4. The time now is 07:47.