CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [DesignModeler] Flow through two geometries (http://www.cfd-online.com/Forums/ansys-meshing/113710-flow-through-two-geometries.html)

mwood February 25, 2013 12:10

Flow through two geometries
 
Hello

So I have a very preliminary question:
I have created a box then I needed a pipe to extrude from one of the faces. So I created a plane and created a circle and extruded it.
When I bring it into fluent the flow wont flow from the pipe to the box.
Any ideas?

stuart23 February 25, 2013 23:56

Hi Megan,

You can either create an interface or unite the solids.

To unite the bodies, use create > Boolean in DM, choose "Unite", then select both bodies.

To create a 1 to 1 mesh interface, select both the bodies in the "bodies" section at the bottom of the tree in DM. Then right-click and "Form New Part". Once meshed, you can assign an interface in Fluent.

Stu


All times are GMT -4. The time now is 00:16.