 |
 |
 |
|
|
|
[Sponsors] | ||||
February 27, 2013, 17:18
|
Cutcell meshing skewness
|
#1 |
|
New Member
Ronato Said
Join Date: Feb 2013
Posts: 2
Rep Power: 0  |
I have decided to use the cutcell method to mesh the volume of fluid around the hull but this method is giving me some trouble with the skewness of some cells ( less than100 cells are highly skewed) which is larger than 0.98. I have tried different sizing functions but this did not help to lower it.
> Do you have any ideas on my current problem which may help me ? is skewness in cutcell a big problem ? (i.e. will fluent have problems in convergence ?) thanks! |
|
|
|
|
|
December 16, 2014, 12:09
|
|
#2 |
|
New Member
Zach Smith
Join Date: Nov 2014
Posts: 1
Rep Power: 0 |
Bump. I am having the same issue with this. I have had this issue with high skewness cells on the edge of cylinders with multiple meshes now. So I believe it is most likely something that I am not doing correctly. Any help would be appreciated.
Thanks |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] Ansys meshing result very high skewness | m5edr | ANSYS Meshing & Geometry | 18 | February 3, 2020 11:35 |
| [ICEM] Meshing problem - skewness | norger | ANSYS Meshing & Geometry | 1 | July 24, 2012 03:44 |
| [ANSYS Meshing] Periodic issues in cutcell meshing | jsm | ANSYS Meshing & Geometry | 7 | March 8, 2012 21:00 |
| [GAMBIT] fac meshing problem, not skewness | bugra | ANSYS Meshing & Geometry | 0 | September 3, 2010 07:40 |
| Severe nonorthogonality and severe skewness problem | qtian | OpenFOAM Running, Solving & CFD | 2 | January 22, 2008 18:47 |
Linear Mode
