|March 9, 2013, 16:13||
Move the coordinate in ICEM
Join Date: Nov 2012
Posts: 168Rep Power: 4
When I finished the mesh using ICEM, I found that the origin is not located in the expected place, but the relative scale of the computational domain is corrrect. So now I would like to move the coordinate system in ICEM. How can I do it in ICEM? I know this will make all the coordinates changed.
Thank you in advance!
|Thread||Thread Starter||Forum||Replies||Last Post|
|PEM Fuel cell module meshes. ICEM vs workbench||aarvay||FLUENT||16||September 15, 2014 11:21|
|[ANSYS Meshing] Workbench 13: Structured Hexa Meshes||rooftop||ANSYS Meshing & Geometry||18||May 13, 2014 04:57|
|[ICEM] complex 2D meshing on ICEM||kassab||ANSYS Meshing & Geometry||26||April 14, 2014 22:02|
|[ICEM] Meshing adjacent wall geometry and simple ICEM questions||everdimension||ANSYS Meshing & Geometry||25||June 20, 2012 05:25|
|Design Modeler to ICEM.....||Joe||CFX||0||January 24, 2008 04:39|