CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [GAMBIT] 3D Modeling Technique in Gambit (Question) (http://www.cfd-online.com/Forums/ansys-meshing/114702-3d-modeling-technique-gambit-question.html)

spincfd March 15, 2013 14:26

3D Modeling Technique in Gambit (Question)
 
1 Attachment(s)
How to project the bigger face to the smaller face by using the straight yellow line as its path or guide?

Far March 16, 2013 02:30

1. Make another edge at leading edge.

2. Use face tool to construct faces from four edge for pressure and suction side.

3. Again use face tool and make the two faces at the tips of wing using two edges at both sides.

4. Go to volume tool and stitch four faces you have just created.

PS. This strategy is for FE mesh. For CFD you need to make the volume outside the wing.


All times are GMT -4. The time now is 16:10.