|
[Sponsors] |
[GAMBIT] 3D Modeling Technique in Gambit (Question) |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 15, 2013, 14:26 |
3D Modeling Technique in Gambit (Question)
|
#1 |
Member
Join Date: Dec 2012
Posts: 30
Rep Power: 13 |
How to project the bigger face to the smaller face by using the straight yellow line as its path or guide?
|
|
March 16, 2013, 02:30 |
|
#2 |
Super Moderator
|
1. Make another edge at leading edge.
2. Use face tool to construct faces from four edge for pressure and suction side. 3. Again use face tool and make the two faces at the tips of wing using two edges at both sides. 4. Go to volume tool and stitch four faces you have just created. PS. This strategy is for FE mesh. For CFD you need to make the volume outside the wing. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[GAMBIT] Canīt start GAMBIT | zalho | ANSYS Meshing & Geometry | 18 | April 8, 2019 02:05 |
gambit crashed | mbgnfrx2 | FLUENT | 1 | August 13, 2009 04:31 |
Gambit modeling troubleshooting | Ng | FLUENT | 1 | March 18, 2005 05:33 |
Gambit batch - kill "Startup" box how? | Chris Bailey | FLUENT | 2 | February 23, 2005 10:05 |
3-D Mesh Check in Gambit..... | SHR | FLUENT | 4 | March 25, 2003 04:10 |