CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [GAMBIT] How to draw a serpentine tube using gambit (http://www.cfd-online.com/Forums/ansys-meshing/115152-how-draw-serpentine-tube-using-gambit.html)

redagogo March 25, 2013 06:46

How to draw a serpentine tube using gambit
 
Hi everyone,

I am a begineer with CFD, I want to draw a serpetine tube in 3D with gambit in order to simulate heat transfer with fluent.

THis is a picture of what i want to draw :

http://french.alibaba.com/product-gs...311689062.html

Can you help me please ?

thanks

redagogo

-mAx- March 25, 2013 07:44

you will use "sweep faces" tool with edge as "path"
http://aerojet.engr.ucdavis.edu/gamb...eom_volm_sweep

But for that you need to create your path: in your case all edges, which will be merged before you will sweep your section (disk)

redagogo March 25, 2013 08:40

thanks , I will try this technic


All times are GMT -4. The time now is 17:03.