|March 25, 2013, 06:46||
How to draw a serpentine tube using gambit
Join Date: Mar 2013
Posts: 2Rep Power: 0
I am a begineer with CFD, I want to draw a serpetine tube in 3D with gambit in order to simulate heat transfer with fluent.
THis is a picture of what i want to draw :
Can you help me please ?
|March 25, 2013, 07:44||
Join Date: Mar 2009
Posts: 3,145Rep Power: 32
you will use "sweep faces" tool with edge as "path"
But for that you need to create your path: in your case all edges, which will be merged before you will sweep your section (disk)
In memory of my friend Hervé: CFD engineer & freerider
|Thread||Thread Starter||Forum||Replies||Last Post|
|Why i need to material properties before fluid draw into the tube in CFD?||fruitkiwi||Main CFD Forum||10||April 3, 2012 07:21|
|Gambit== how to draw a 180 degree curved rectangular in gambit||zaolon88||FLUENT||0||March 25, 2012 01:17|
|How to DRAW CURVE ON GAMBIT??||teguhtf||FLUENT||2||September 16, 2009 03:25|
|how to draw camber line of an airfoil in Gambit||Muhammad Usman Qureshi||FLUENT||1||September 15, 2009 19:40|
|how to draw journal bearing fluid using gambit??||zidane||FLUENT||0||March 8, 2009 13:40|