CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] Problem: Blayer 2d inflation layer (http://www.cfd-online.com/Forums/ansys-meshing/115262-problem-blayer-2d-inflation-layer.html)

j_h_86 March 27, 2013 06:12

Problem: Blayer 2d inflation layer
 
1 Attachment(s)
Dear all,

I want to create an inflation layer in a 2D Tri-mesh. Therfore I turned on the Blayer 2d option and specified the curve parameters for the curve, which should be inflated.

This works fine except for the beginning and for the end of the curve, where other orthogonal curves meets the inflated BL (see attached image).

Any help would be appreciated.

Best regards


All times are GMT -4. The time now is 07:37.