[DesignModeler] mesh only fluid and keep impeller for dynamic simulation

vonkam · April 10, 2013, 04:36

Hello everybody,

I am using ansys modeler for a mixed tank reactor, but I am pretty fresh to CFD. With a herculean effort I have drawn my reactor, mixing zones and impeller, but I cannot figure how to mesh fluid only in 2 sections and keep the baffles and impeller for dynamic simulation in Fluent. Attatched figure might help or show my mistakes.
Can anybody give me advice?

Thanks
Michal

Far · April 10, 2013, 14:18

I have done similar case with full hexa mesh. If interested, I can send you blocking files.

vonkam · April 10, 2013, 15:14

Thanks a lot Far.
Michal

Far · April 18, 2013, 06:41

files sent to you are helpful?

vonkam · April 18, 2013, 07:47

Yep, they were very helpful. I am already running my simulations. Thanks.

April 10, 2013, 15:14		#3
vonkam New Member Michal Vonka Join Date: Apr 2013 Posts: 5 Rep Power: 13	Thanks a lot Far. Michal Last edited by vonkam; April 12, 2013 at 05:55.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

April 10, 2013, 14:18		#2
Far Super Moderator Sijal Join Date: Mar 2009 Location: Islamabad Posts: 4,553 Blog Entries: 6 Rep Power: 54	I have done similar case with full hexa mesh. If interested, I can send you blocking files.

April 18, 2013, 06:41		#4
Far Super Moderator Sijal Join Date: Mar 2009 Location: Islamabad Posts: 4,553 Blog Entries: 6 Rep Power: 54	files sent to you are helpful?

April 18, 2013, 07:47		#5
vonkam New Member Michal Vonka Join Date: Apr 2013 Posts: 5 Rep Power: 13	Yep, they were very helpful. I am already running my simulations. Thanks.