|
[Sponsors] |
April 13, 2013, 23:17 |
Quality or Skewness
|
#1 |
Senior Member
Astio Lamar
Join Date: May 2012
Location: Pipe
Posts: 186
Rep Power: 13 |
Hi!
I want to know which parameters of Quality or Skewness improvement in more important? If one's want to improve the mesh quality, the effort should be on improving the Quality or Skewness? these two are more or less related to each other, but in some cases with improving quality, the mesh skewness become a bit worse and vice versa. Thanks. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mesh quality problems: maximum skewness larger than 0.98 | cth_yao | FLUENT | 4 | May 19, 2016 11:59 |
[ICEM] The pre-mesh quality is very good but the mesh quality is bad | lnk | ANSYS Meshing & Geometry | 5 | July 30, 2012 15:11 |
[Netgen] Import netgen mesh to OpenFOAM | hsieh | OpenFOAM Meshing & Mesh Conversion | 32 | September 13, 2011 06:50 |
[ICEM] Hex refinement negative quality afterwards | Anorky | ANSYS Meshing & Geometry | 8 | March 22, 2010 04:25 |
Severe nonorthogonality and severe skewness problem | qtian | OpenFOAM Running, Solving & CFD | 2 | January 22, 2008 19:47 |