CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > ANSYS Meshing & Geometry

[ICEM] Quality or Skewness

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   April 13, 2013, 22:17
Default Quality or Skewness
  #1
Senior Member
 
Astio Lamar
Join Date: May 2012
Location: Pipe
Posts: 156
Rep Power: 5
asal is on a distinguished road
Hi!

I want to know which parameters of Quality or Skewness improvement in more important? If one's want to improve the mesh quality, the effort should be on improving the Quality or Skewness? these two are more or less related to each other, but in some cases with improving quality, the mesh skewness become a bit worse and vice versa.
Thanks.
asal is offline   Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
[ICEM] The pre-mesh quality is very good but the mesh quality is bad lnk ANSYS Meshing & Geometry 5 July 30, 2012 14:11
mesh quality problems: maximum skewness larger than 0.98 cth_yao FLUENT 3 January 27, 2012 06:50
Import netgen mesh to OpenFOAM hsieh Open Source Meshers: Gmsh, Netgen, CGNS, ... 32 September 13, 2011 05:50
[ICEM] Hex refinement negative quality afterwards Anorky ANSYS Meshing & Geometry 8 March 22, 2010 04:25
Severe nonorthogonality and severe skewness problem qtian OpenFOAM Running, Solving & CFD 2 January 22, 2008 19:47


All times are GMT -4. The time now is 20:10.