|
[Sponsors] |
April 23, 2013, 03:07 |
tetra meshing error
|
#1 |
Senior Member
S.Bogoda
Join Date: Jul 2012
Posts: 133
Rep Power: 13 |
Hi all,
I am receiving a error message, error deleting "./tetra_cmd.log" : permission denied Can anybody tell me what is the reason for this message? Thanks. |
|
April 23, 2013, 11:08 |
|
#3 |
Senior Member
S.Bogoda
Join Date: Jul 2012
Posts: 133
Rep Power: 13 |
hi Ali,
yes, I saved the project and there is enough memory. But whenever I tried to mesh (quit dense mesh), this error appeared. Is there any limit for meshing? Because this happened while refining or for small scale factors. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem running perturbUCyl | sen.1986 | OpenFOAM | 17 | June 4, 2019 05:56 |
ParaView for OF-1.6-ext | Chrisi1984 | OpenFOAM Installation | 0 | December 31, 2010 06:42 |
UDF: DEFINE_CG_MOTION for vertical jump motion of an electrode! | alban | Fluent UDF and Scheme Programming | 2 | June 8, 2010 18:54 |
[swak4Foam] groovyBC: problems compiling: "flex: not found" and "undefined reference to ..." | sega | OpenFOAM Community Contributions | 12 | February 17, 2010 09:30 |
error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 15:16 |