|April 23, 2013, 22:09||
How to creat surface from this geometry with icemcfd
i have create the following channel. but could you please tell me how to creat two surfaces.
the middile wavy wall was created with many segment. but icemcfd can only creat surface with 2-4 lines. how to combine the way wall segments into one line
|April 26, 2013, 11:01||
Ghazlani M. Ali
Join Date: May 2011
Blog Entries: 23Rep Power: 20
you can create one big surface, and use build topology to automatically split it when curves are met...
New to ICEM CFD, try this document --> http://goo.gl/G2gkE
|Thread||Thread Starter||Forum||Replies||Last Post|
|Solution Snappy Hex 2D Msh with Surface Layers and cyclic bc for symmetric geometry||flexi182||OpenFOAM Native Meshers: snappyHexMesh and Others||0||May 24, 2013 08:38|
|boundaries with gmshToFoam||ouafa||Open Source Meshers: Gmsh, Netgen, CGNS, ...||7||May 21, 2010 12:43|
|Simulation of Flow through Complex 3D Geometry||EmersonKB||CFX||5||July 2, 2009 08:17|
|Icemcfd 11: Loss of mesh from surface mesh option?||Joe||CFX||2||March 26, 2007 18:10|
|vitual _ real||deneb||FLUENT||3||January 22, 2007 05:31|