|May 6, 2013, 10:36||
3D model turbine housing mesh
Join Date: May 2013
Posts: 2Rep Power: 0
Hi I am working on a project of turbocharger,
here casing model is done in nx software and i need mesh in icem software.
i have meshed it but quality of mesh is not good as shown in photo. so anyhow i need 2 get this quality more than 30% to proceed with turboGrid analysis. so plz help me to achieve this.
here are the step that have done for meshing.
1 imported igs file in icem
2 in mesh- surface mesh setup
maximum size -100
num of layers-5 - apply
4 compute mesh
Last edited by moseen; May 6, 2013 at 10:38. Reason: not uploaded the photo
|Thread||Thread Starter||Forum||Replies||Last Post|
|CFD analysis on wind turbine rotor||Ken (Wind Turbine CFD Super Rookie)||Main CFD Forum||45||February 9, 2016 15:07|
|Add Mesh Layers doesnt work on the whole surface||Kryo||OpenFOAM Native Meshers: snappyHexMesh and Others||8||September 13, 2012 09:28|
|Layers:problem with curvature||giulio.topazio||OpenFOAM Native Meshers: snappyHexMesh and Others||10||August 22, 2012 09:03|
|fluent add additional zones for the mesh file||SSL||FLUENT||2||January 26, 2008 12:55|
|Icemcfd 11: Loss of mesh from surface mesh option?||Joe||CFX||2||March 26, 2007 18:10|