 |
 |
 |
|
|
|
[Sponsors] | ||||
May 7, 2013, 18:00
|
Cell Face as a boundary condition
|
#1 |
|
New Member
Gladson
Join Date: May 2013
Posts: 1
Rep Power: 0  |
Hi Everyone,
I want to know if its possible to select a specific cell face and set this as a boundary condition, like inlet? I'm trying to build a strutured mesh and set a group of cell faces as an inlet boundary, specified by velocity. I'm using the ANSYS Meshing and also the ICEM CFD. Any tip? Thanks! 
|
|
|
|
|
 |
| Tags |
| boundary condition, cell face |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CFX fails to calculate a diffuser pipe flow | shenying0710 | CFX | 7 | March 26, 2013 05:13 |
| mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 12 | December 12, 2011 04:16 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
| Slip boundary condition what is inside | normunds | OpenFOAM Running, Solving & CFD | 2 | June 4, 2007 06:45 |
| FvMatrix coefficients | shrina | OpenFOAM Running, Solving & CFD | 8 | November 22, 2006 10:31 |
Linear Mode
