|May 8, 2013, 05:00||
2D Mesh from ICEM to ANSYS FLUENT
Join Date: May 2013
Posts: 34Rep Power: 5
I started to work with ICEM CFD and FLUENT and I got a small problem.
I created a rectangular surface (2D model) in ICEM, created a simple mesh and wrote an output file for Fluent. To this point everything worked well.
I opened Fluent and tried to open the file but then the following text appears and the only thing left of my mesh is a single straight line.
What did I do wrong? Its probably a stupid question but I would be happy about help.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Export 2D mesh from ICEM to Fluent||enghamed||ANSYS Meshing & Geometry||18||August 10, 2015 20:49|
|[ICEM] ICEM incapable of writing ANSYS input mesh with midside nodes||ampa||ANSYS Meshing & Geometry||0||April 24, 2013 05:23|
|[ICEM] Cannot load ICEM mesh in FLUENT||htnyc||ANSYS Meshing & Geometry||4||July 19, 2012 22:02|
|[ICEM] Export unstructured periodic mesh from ICEM CFD to Fluent||ivanddd||ANSYS Meshing & Geometry||1||February 3, 2011 01:51|
|few quesions on ANSYS ICEMCFD and FLUENT||Prakash.Paudel||ANSYS||0||August 12, 2010 12:07|