|May 8, 2013, 22:13||
highly skewed elements in gambit
Join Date: Apr 2010
Posts: 23Rep Power: 7
i'm trying to mesh a gas turbine blade with cooling holes using Gambit, the mesh is structured, but in when i mesh a volume a message appears "mesh of volume 56 contains 36 highly skewed elements", however Gambit mesh the volume, at other times a similar message appears too, but Gambit dont allow to mesh the volume. my question is: if Gambit allow to mesh the volume can i to use this mesh? the area where the highly skewed elements are located isn't the area that i try to analyze.
thanks in advance guys
|May 13, 2013, 01:37||
Join Date: Mar 2009
Posts: 3,027Rep Power: 31
highly skewed cells mentionned from Gambit have skewness greater than 0.97, which should faild check mesh in fluent.
You can try working with this mesh, but if it diverges, or doesn't start, you know what you have to do...
In memory of my friend Hervé: CFD engineer & freerider
|Thread||Thread Starter||Forum||Replies||Last Post|
|Highly Skewed Cells||chrisoturner||FLUENT||7||July 22, 2010 06:43|
|[GAMBIT] 3D skewed elements||chris21||ANSYS Meshing & Geometry||2||May 6, 2010 21:15|
|active analysis elements in GAMBIT||yan||FLUENT||0||April 28, 2006 01:46|
|highly skewed elements||srikanth||Main CFD Forum||1||February 21, 2006 09:15|
|Gambit: skewed mesh||Christoph||FLUENT||1||November 7, 2005 13:32|