CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] Volume Generation Problem (http://www.cfd-online.com/Forums/ansys-meshing/117477-volume-generation-problem.html)

IbrahimSher May 9, 2013 01:56

Volume Generation Problem
 
4 Attachment(s)
There are four attachments with this question
1. Surface Mesh
2. Orfn defined using build topology
3. Boundary Sphere
4. Disoriented :confused: volume mesh
How to correct this volume mesh?

jeevankumarb May 10, 2013 05:39

Did you check the mesh for errors? if there are no errors then the mesher is not able to find a closed body. try to move the material body point inside the domain.

diamondx May 11, 2013 17:20

make sure the body FLUID is outside the plane. you enclosure is not big enough, might give you problem with convergence


All times are GMT -4. The time now is 09:05.