 |
 |
 |
|
|
|
[Sponsors] | ||||
April 29, 2013, 04:37
|
issue with skin/loft
|
#1 |
|
Member
Dr. Moloy Kumar Banerjee
Join Date: Jun 2011
Posts: 71
Rep Power: 14  |
Dear all,
is it possible to do the skin/loft operation considering two circle of different diameter along a particular line? Any help is highly appreciated. |
|
|
|
|
|
April 29, 2013, 06:41
|
|
#3 |
|
Member
Dr. Moloy Kumar Banerjee
Join Date: Jun 2011
Posts: 71
Rep Power: 14 |
thanks for the reply. Actually what i intend to do is the two circles that u have lofted should be along a specified line, not along the line the design modeler shows
|
|
|
|
|
|
|
April 30, 2013, 01:12
|
|
#5 |
|
Member
Dr. Moloy Kumar Banerjee
Join Date: Jun 2011
Posts: 71
Rep Power: 14 |
I want to do the 3D model of the attached figure, where both the outer wall and the inner wall are the function of 'x'. My objective is to loft the two circles (marked in red) at two different planes along a particular line (marked with green), so that I can configure the branch portion of the pipe.
If there is other alternative approach to the problem? If it is so, then give some idea about how to do it. Thanks in advance |
|
|
|
|
|
|
May 13, 2013, 06:17
|
|
#6 |
|
Member
Dr. Moloy Kumar Banerjee
Join Date: Jun 2011
Posts: 71
Rep Power: 14 |
any help in this regard...
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CyclicAMI Issue In OpenFOAM 2.2.0 | prasant | OpenFOAM Running, Solving & CFD | 17 | March 16, 2013 02:00 |
| Pressure boundary condition issue | Vijay | FLUENT | 0 | April 6, 2012 13:35 |
| Meshing related issue in Flow EFD | appu | FloEFD, FloWorks & FloTHERM | 1 | May 22, 2011 08:27 |
| skin/loft error | fkonias | CFX | 0 | June 6, 2008 10:43 |
| Issue 4 of adapco-online | Sreenadh Jonnavithula | Siemens | 0 | December 21, 2000 13:41 |
Linear Mode
