|May 17, 2013, 23:38||
Weird protrusions in mesh after Octree
Join Date: Oct 2012
Posts: 133Rep Power: 6
I have this weird problem in ICEM. After i created my mesh using the Octree Mesh Method, the mesh became slightly deformed. As such, I keep getting errors when i try to include prismatic layers on it. Not sure if the errors I'm getting are due to this deformation but it probably is. Is there a way around this? This is what I did.
1. Imported Geometry as an IGES.
2. Built topology ( all red lines)
3.Set mesh parameters and meshed it using the Octree algorithm.
4. deleted the volume mesh to try to fix all the holes , and deformation but to no avail. Attached is my mesh.
This is seriously causing me a lot of sleep.
Many thanks in advance.
|May 18, 2013, 08:26||
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Blog Entries: 23Rep Power: 21
apply a certain number of number in that edge... see what it does... you can also share your project ...
New to ICEM CFD, try this document --> https://goo.gl/NEbygB
|May 19, 2013, 20:09||
Join Date: Dec 2009
Posts: 129Rep Power: 11
looks like you are missing the edge curve defining the geometry in that area.
Get that edge in there and even without defining nodes on there it will automatically pick up the sizing from the part it is associated with.
Unless there is a thin spacing to the other side of geometry (surfaces) and then you will need to define some thin cuts in the octree settings.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Star CCM Overset Mesh Error (Rotating Turbine)||thezack||CD-adapco||7||October 12, 2016 11:14|
|[ICEM] surface mesh merging problem||everest||ANSYS Meshing & Geometry||44||April 14, 2016 06:41|
|[ANSYS Meshing] WARNING: 1 cell(s) have only wall faces. Error using Octree Mesh Method||davidwilcox||ANSYS Meshing & Geometry||7||January 23, 2013 06:16|
|Layers:problem with curvature||giulio.topazio||OpenFOAM Native Meshers: snappyHexMesh and Others||10||August 22, 2012 09:03|
|basic of mesh refinement||arya||CFX||4||June 19, 2007 12:21|