CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [Other] Part does not show up in CFX-Pre (http://www.cfd-online.com/Forums/ansys-meshing/117984-part-does-not-show-up-cfx-pre.html)

darazsbence May 18, 2013 14:13

Part does not show up in CFX-Pre
 
Hello Everyone,

I did a mesh in Icem and created a part (it is a surface) and then i made the cfx5 file. After i import this file in cfx pre the part is not the same as i created (it is smaller) and i don't know why. It is very frustrating. Any ideas?

Thanks

Far May 18, 2013 15:06

May be it is visual artifact!!

ShowponyStuart May 20, 2013 05:02

Have you checked to your scale to make sure ICEM and CFX are working in the same units?


All times are GMT -4. The time now is 08:01.