CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [DesignModeler] Design Modeler does not open on Red Hat 5.7 (

victorz May 19, 2013 10:44

Design Modeler does not open on Red Hat 5.7
Hi all,

I performed a system update of my Red Hat 5.7 installation.
Since that update, Design Modeler would not start at all.

When I start it, it prints out a line "Opening Design Modeler" but nothing happens. When I check the license status, it shows that the DM license is taken, without opening the program itself.

I guess it's some kind of graphic package mismatch with DM requirements. Can you please suggest what package it might be?

Any other ideas?


Philip_C July 31, 2013 03:21

Hi Victorz,

I am facing the same trouble...

vasava July 31, 2013 03:58

May be some issues with graphics.

mjgraf July 31, 2013 09:33

you just updated and it updated to 5.7 or to 5.9?

There is a known issue with 5.9 that has a patch available on the support page.

All times are GMT -4. The time now is 21:28.