 |
 |
 |
|
|
|
[Sponsors] | ||||
May 17, 2018, 06:27
|
[SpaceClaim]Anchoring sketch curves
|
#1 |
|
Member
António Soares
Join Date: Mar 2015
Location: Lisbon, Portugal
Posts: 48
Rep Power: 11  |
Greetings,
I've been enjoying learning about SpaceClaim but there are things about it that I still find infuriating. Is there not way to fix anchor a sketch curve so that I can set the length of a straight line and have a perpendicular line merely extend its length to match it instead. Since there are almost no sketch relations I can't seem to force certain constraints on my sketch curves. What's the best workaround for this? Thanks |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Attached geometry curves | niablis | ANSYS Meshing & Geometry | 1 | October 7, 2020 05:59 |
| [ICEM] Surface does not follow curves, ICEM | yonpanman | ANSYS Meshing & Geometry | 1 | January 6, 2017 05:29 |
| [ICEM] Error 2D mesh - Separate curves seen as one when associating | bbmorales | ANSYS Meshing & Geometry | 3 | June 11, 2013 11:56 |
| [ANSYS Meshing] Boolean Subtraction of 3D Curves with Circular Cross-Section from Cube? | ANT | ANSYS Meshing & Geometry | 5 | September 12, 2012 12:19 |
| Version 7.04 : disappearing feature curves and other woes | nomad | STAR-CCM+ | 2 | September 4, 2012 21:07 |
Linear Mode
