CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ANSYS Meshing] Surface Orientation Problem (

Lisandro Maders May 22, 2013 13:27

Surface Orientation Problem
Hi, I know there are a lot of threads about this problem, but in anyne somebody gives a good SOLUTION to the problem (unless I did'nt see it).

Well, to sumirise, when I check my mesh, which have about 2 milion of elementes, there are ONLY 4 elements with surface orientation problems.. When I try to create the .msh file for Fluent, I got the following message:

"Error : face (near node 14578) is attached to more than 2 cells."

Well, what I need to do?? Please give me solutions!

And if there is some thread with the answer and I didn't see it please, send me the link!

Thank you!

All times are GMT -4. The time now is 09:11.