CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [DesignModeler] how to add a node? (http://www.cfd-online.com/Forums/ansys-meshing/118388-how-add-node.html)

itsqi7 May 26, 2013 23:16

how to add a node?
 
1 Attachment(s)
Hi there,

I hope to use Vertex sizing control in my mesh to refine certain region. But I don't know how to add a node into the model.:eek: Can anyone told me how to do that? My model is created in Creo and used to play a CFX simulation.
Attachment 22129

Thanks,
itsqi7

jrunsten May 27, 2013 02:08

If it's refinement you are looking for, then you can use "sphere of influence" for body sizing:

http://i.imgur.com/6TYnfbZ.png

All you need is to define a coordinate system at your point.

itsqi7 May 27, 2013 03:51

Quote:

Originally Posted by jrunsten (Post 430174)
If it's refinement you are looking for, then you can use "sphere of influence" for body sizing:

http://i.imgur.com/6TYnfbZ.png

All you need is to define a coordinate system at your point.

Thanks a lot. I found it in the Mesh. I tried to add plane in designmodeler but it didn't work. So now it works. :)


All times are GMT -4. The time now is 17:11.