|June 4, 2013, 07:39||
Closed Loop Meshing
Join Date: Nov 2012
Posts: 34Rep Power: 4
I am trying to model a Natural circulation loop using 2-D geometry.Since the geometry is a rectangular closed loop, I am unable to generate cells perpendicular to the length of the loop.Generating cells along the length of the loop is straightforward using "Edge Sizing" option.I am attaching the mesh for upper half of the rectangular loop for clarification.I am new to this and any help would be appreciated.thnx.
Last edited by Thermal_engg; June 4, 2013 at 10:36.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Help UDF to Boundary Conditions in Closed Loop Pipe||Blader||Fluent UDF and Scheme Programming||2||May 14, 2012 10:48|
|my stl surface is seen as just a line||rcastilla||OpenFOAM Meshing & Mesh Conversion||2||January 6, 2010 02:30|
|Problem with Gmsh||nishant_hull||Open Source Meshers: Gmsh, Netgen, CGNS, ...||17||December 7, 2007 02:33|
|NACA0012 geometry/design software needed||Franny||Main CFD Forum||13||July 7, 2007 16:57|
|Flow in a Closed Loop||John Collins||Main CFD Forum||2||February 27, 2003 11:26|