Error 2D mesh - Separate curves seen as one when associating
Hello there.
I have been dealing with the same problem over and over in ICEM 14.0, maybe you can help me. I am creating a simple 2D mesh, following the procedure below: 1) create points 2) create curves from points 3) create parts from curves 4) create planar 2D block 5) associate edges to curves 6) define pre-mesh params 7) convert to unstructured mesh 8) output to FLUENT What happens is when I read the mesh in FLUENT, the boundary conditions (related to the parts) can't be seen. Going back to ICEM, I noticed that when I check the Info of each part, the missing parts contains no elements - as if the was no edge association to them. I tried to redo the edge association to the curves and then I have found that when I try to select the a single curve (related to a part), I can only select all curves at once. The only solution I've found so far is to deleted all the geometry and build it again. Any idea? Am I doing something blatantly wrong? Cheers |
Hi Bayard,
Once you have done the association, if you want to select only a part of one curve you need to Ungroup the curve. So, for do that, you have to click in Blocking -> Group/Ungroup Curves -> Action "Ungroup Curves" -> Select curve or curves. |
|
[SOLVED]
Far and FJSJ Thanks for your prompt answer! The problem was that the curves were grouped - as pointed out by FJSJ. Ungrouping the curves solved the issue. Best regards! |
All times are GMT -4. The time now is 17:47. |