|
[Sponsors] |
June 18, 2013, 18:46 |
Help creating a 2D interface
|
#1 |
Member
Arthur Loginow
Join Date: Aug 2012
Posts: 99
Rep Power: 13 |
Hello, I am having issues to create the interface between different zones, I think that my mistake comes from the geometry modeling but I am not too sure about that, this is what I do:
-I create the main geometry (rectangular shape with 2 holes at the middle) -Now I create 2 new circles (they are a offset of the holes in the middle) -I use the lines from sketch option -I project those lines This procedure gives me 3 faces, but I am not sure that I am doing it the right way, please some help. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 02:13 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 07:28 |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 08:00 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |