|June 25, 2013, 08:48||
Pipe (thinwalled) in a block
Join Date: Jun 2013
Posts: 1Rep Power: 0
here is my first try with ICEM CFD.
I'm Civil Engineer and my daily work is more
in structural than CFD.
Therefore I'm using usually shell and beam elements
Now, there is a problem which makes the use of
volume elements affordable.
There is an part of an masonry ring (7 m diameter) with
an cantilever pipe clamped.
Between the pipe 193.7 x 8 mm and the masonry (and 5 cm deeper) is a ring of mortar (29 cm diameter).
My wish is, to get only a hexa mesh for these three elements (materials).
The pipe should be 1 - max 2 element thick and the elements for pipe and mortar should be oriented in a circle mesh in the block of masonry.
I've tried a little bit, but I don't find out the right blocking for good meshing.
Especially for the pipe I found no usefull solution.
Is there anybody out there ... who can give me some hints.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Pipe with 2 outlets block strategy||FJSJ||ANSYS Meshing & Geometry||2||June 11, 2013 10:42|
|[ANSYS Meshing] block and mesh pipe in pipe||Nunuuika||ANSYS Meshing & Geometry||3||November 28, 2011 05:26|
|Icem Mesh to Foam||jphandrigan||OpenFOAM Mesh Utilities||4||March 9, 2010 03:58|
|Terrible Mistake In Fluid Dynamics History||Abhi||Main CFD Forum||12||July 8, 2002 09:11|
|fluid flow fundas||ram||Main CFD Forum||5||June 17, 2000 21:31|