CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] thin cut problem (http://www.cfd-online.com/Forums/ansys-meshing/119848-thin-cut-problem.html)

feizaghaee June 26, 2013 05:57

thin cut problem
 
hi all. I'm meshing a weir which has a thin cut. when I set edge criterion smaller than 0.03 after performing a tera mesh ICEM says that there is a hole in my geometry. how can I fix this problem?
thanks in advance


All times are GMT -4. The time now is 22:26.