|
[Sponsors] |
June 26, 2013, 04:57 |
thin cut problem
|
#1 |
Senior Member
|
hi all. I'm meshing a weir which has a thin cut. when I set edge criterion smaller than 0.03 after performing a tera mesh ICEM says that there is a hole in my geometry. how can I fix this problem?
thanks in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
area does not match neighbour by ... % -- possible face ordering problem | St.Pacholak | OpenFOAM | 10 | February 7, 2024 21:50 |
conduction problem | venkataramana | OpenFOAM | 3 | December 1, 2013 07:30 |
Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 19:42 |
Problem in implementing cht | tilek | CFX | 3 | May 8, 2011 08:39 |
Thin surfaces within a body using DesignModeler? | Forrest | CFX | 7 | April 5, 2005 08:21 |